Drip edge and gutter flashing are thin metal pieces at the roof edge that direct water off the shingles and into the gutter instead of behind it. When they are missing, bent or too short, fascia rots and gutters pull away. Call the number on this page to be connected with a local gutter company in Denver.

What drip edge and flashing do
Drip edge is an L-shaped metal strip fitted along the eave and rake of a roof. It carries water past the fascia board and into the gutter. Gutter flashing, sometimes called back flashing or an apron, bridges the gap between the shingles and the back of the gutter so water cannot slip behind it. Together they protect the fascia, the soffit and the wall below.
Signs something is missing or failing
- Water stains, peeling paint or soft spots on the fascia behind the gutter
- Water running down the back of the gutter or the wall during rain
- Gutters that pull away from the house at the top
- Shingles that overhang the gutter by too little or too much
- Rust streaks or bent metal along the eave
The Denver angle
Denver has hail, wind and freeze-thaw, and each one works on the roof edge. Hail dents thin metal and bends drip edge, wind lifts loose pieces, and meltwater that refreezes behind a gutter forces its way into small gaps. Older homes in the city's core sometimes have no drip edge at all, and fascia there is often wood that has taken decades of weather.
Roof permits in Denver
Denver Community Planning and Development says roof repair or replacement needs a permit when the work covers more than 10 percent of the roof area or two roof squares, whichever is smaller. Its quick-permit page does not address gutters. If drip edge is replaced as part of a larger roofing job, the roofer typically handles the permit. Ask who is responsible before work starts.
What happens on a visit
A local gutter company looks at the eave from the ground and ladder, checks fascia condition, and decides whether to add or replace flashing behind existing gutters, replace drip edge in sections, or take the gutter down so the metal can be fitted properly. If the fascia is soft, that gets repaired first, or the new gutter will hang from rot.
Repair or replace
Adding flashing behind a good gutter is a modest repair. If gutters are old, dented and pulling loose, replacing them at the same time avoids doing the work twice. For a cost range on new gutters, see the gutter replacement page.
Stay safe
Do not work from a roof edge or a tall ladder yourself, keep away from power lines, and avoid wet or icy days.
Drip Edge & Gutter Flashing questions from Denver homeowners
What is the difference between drip edge and gutter flashing?
Do I need a permit in Denver to add drip edge?
Why is my fascia rotting behind the gutter?
Can flashing be added to existing gutters?
Related gutter repair services in Denver
Helpful guides
Drip Edge & Gutter Flashing in nearby cities and towns
Arapahoe County
Jefferson County
Adams County
Douglas County
Broomfield County
Boulder County
Weld County
Elbert County
Larimer County
Clear Creek County
Gilpin County
Park County
Sources
Last updated: