Gutter repair referrals for Denver & nearby townsCall: (720) 868-9072
(720) 868-9072

Drip Edge & Gutter Flashing in Boulder, CO

gutterrepairdenver.net

Gutter flashing is easy to overlook until fascia starts to rot, and an independent local company near Boulder can sort out what the roof edge needs.

Want the roof edge checked in Boulder?
Call now to be connected with a local gutter company in Boulder.
(720) 868-9072

A gutter apron or back flashing bridges the gap between shingles and gutter, and it often fixes leaks that look like a gutter problem. Call the number on this page to be connected with a local gutter company in Boulder.

Drip edge flashing at a roof edge above a gutter, drip edge & gutter flashing in Boulder, CO

Signs of missing drip edge

Bare wood at the roof edge, shingles resting directly on the fascia and rot that starts at the top of the board all hint that no metal edge is guiding water away. Older homes often lack it altogether. Check under the first row of shingles from below if you can see it.

How the pieces fail

Drip edge can be missing, too short, bent by ice or rusted through. Gutter flashing may be installed over the shingles in the wrong order, sealed with caulk that dried out, or knocked loose when snow slid off the roof. Any one failure can send water behind the trough.

Call now to be connected with a local gutter company in Boulder.
(720) 868-9072

Added with the gutters or on its own

It is usually less work to add flashing while the gutters are being replaced or re-hung, since the trough is already off the house. Doing it separately means taking sections down and putting them back. Ask what changes in the quote if the gutters stay up.

Useful local facts for Boulder

The permitting office for Boulder is the Boulder Planning & Development Services. A company that works here regularly will know whether your project needs anything filed.

On permits, the City of Boulder notes this: Roofing replacement is listed as a permit type; the page does not say whether gutter replacement needs a permit.

For structural design, the City of Boulder uses a ground snow load of 40 psf. Heavy, wet spring snow loads gutters too, which is why hanger spacing matters here.

Much of the metro sits on clay soils that swell when wet, so downspouts should carry water well away from the foundation.

The Front Range sees frequent hail from late spring through summer, and soft aluminum gutters dent easily. Photograph damage before anything is replaced.

Nearby, the same kind of help is available in Louisville, Superior and Niwot.

Getting it in writing

Ask for the number of feet, type of metal, where it will go and how it will lap, plus any fascia work. A written scope helps you compare independent local companies and know what was done after the crew leaves. Photographs of the finished edge are worth keeping too.

Don't just caulk it

A tube of sealant along the gap may stop drips for a season, but it often traps moisture and hides rot. If you suspect a flashing problem, get it properly diagnosed rather than patching over it. Short-term fixes can make longer-term repairs more expensive.

More about Boulder

Calls come in from across Boulder, including around US 36, Pearl Street Mall, Flatirons.

Drip Edge & Gutter Flashing questions in Boulder

What is drip edge?
It is a bent metal strip along the roof edge that guides water off the shingles and into the gutter.
What is a gutter apron?
A longer flashing that tucks under the shingles and laps over the back of the gutter to bridge the gap.
Does flashing matter at wall corners?
Yes. Where a gutter ends at a wall or valley, missing flashing lets water get behind trim and siding.
Can ice damage drip edge?
Yes, sliding ice and snow can bend it and open gaps, and frozen water behind it can lift the metal.

More gutter repair services in Boulder

Drip Edge & Gutter Flashing nearby

Call now to be connected with a local gutter company in Boulder.
(720) 868-9072

Last updated:

☎ Call (720) 868-9072