Aluminum is the standard gutter metal for Colorado homes because it is light, does not rust, and can be rolled seamless on site. A local company can hang new runs, reseal or patch what you have, or replace the whole system. Call the number on this page to be connected with a local gutter company in Lakewood.

Why aluminum is the usual choice
Walk down almost any street near Edgewater and the gutters are aluminum. The metal is light enough for ordinary fascia, it does not rust through, and a crew can roll it into one long piece on site. Baked-on color means no regular painting.
Corners, end caps and outlets
Seamless does not mean jointless. Corners, end caps and downspout outlets are still sealed pieces, and those spots are where aluminum gutters usually start to weep. A careful crew seals each one, adds rivets where needed, and lines up the outlets with the downspouts.
Much of Lakewood's housing dates to the 1970s, so the fascia behind aluminum gutters may be softer than it looks. Expect the crew to check the boards first.
| Factor | Effect on the quote |
|---|---|
| Roof edge length | More material and labor |
| Second story | Slower, more setup |
| Six-inch profile | Higher material use |
| Rotted fascia | Extra carpentry |
Complex rooflines add corners, and every corner adds sealing work and material. Tight side yards, fences and landscaping can slow a crew too, and that shows up in the quote.
Snow and ice on the run
Wet spring snow is heavy, and it slides off a warm roof in sheets. That load can bend aluminum, pop hangers and tear the front lip. Ice damming adds weight along the eave. Closely spaced hidden hangers and firm fascia keep a run from sagging.
Know this about Lakewood homes
Lakewood is under the City of Lakewood, and building permits there go through the Lakewood Public Works Building Division. Gutter work alone often needs none, but a re-roof usually does, so ask the company which applies to your job.
On permits, the City of Lakewood notes this: Re-roofing needs a roofing permit before tear-off; small repairs under 100 square feet do not. The city's guide requires metal drip edge at all eaves but does not address gutters.
The ground snow load in the City of Lakewood's building code is 30 psf. Snow sliding off the roof is hard on gutters, so ask about hanger type and spacing.
Hail is a regular part of summer along the Front Range. Dented gutters and downspouts are often among the first things an adjuster notes after a storm.
Companies that take calls here usually also work in Edgewater, Wheat Ridge and Sheridan.
Matching new to old
Adding one new section to an older run can leave a color mismatch, because paint fades over time. Some owners accept it; others replace the whole elevation so the look is even. Mention it early, since the installer may match the finish closely.
Around Lakewood
Calls come in from across Lakewood, including around Belmar, Green Mountain, Bear Creek Lake.
Aluminum Gutters questions in Lakewood
Are aluminum gutters a good choice in Lakewood?
How long do aluminum gutters last?
Will aluminum gutters handle heavy snow?
Is aluminum a good match for older homes?
More gutter repair services in Lakewood
Aluminum Gutters nearby
Helpful guides
Sources
Last updated: